Hydraulic Components - Controllers

Controllers

Within flow systems, it is often desired to control flow or pressure at a given location. To achieve this goal some type of control device is needed. The curve data (Cv vs. %open or Kv vs. %open) from the control valve manufacturer can be defined in the database to incorporate into the system design. Users have the option to automatically size the control valve to determine the flow coefficient (Cv) for the defined operating conditions, i.e., control valve set point.

The table below shows the application of different controller elements available in the FluidFlow database:

The table below shows the required data input and the output for the controller components. Note that the results table varies depending upon the fluid phase state and the visible properties selected by the user.

 

• Related Articles

• Hydraulic Components - Boundaries

  Boundaries Hydraulic models operate with single or multiple origins and destination points. These "points" are called boundaries within the concept of FluidFlow. Boundaries are therefore the points where the model starts and terminates. Correct ...

• Hydraulic Components - Boosters

  Boosters Booster is a general term for any fluid machine that adds energy to a fluid and is commonly called an energy-absorbing device. Boosters are mechanical devices that transport fluid from source to destination by increasing fluid pressure. ...

• Hydraulic Components - Size Change

  Size Change Size change components bring about a sudden change in velocity at the component. This can be caused by a change in the size of inlet and outlet pipes or by a sudden constriction. In FluidFlow, the thin sharp-edged orifice, thick orifice, ...

• Hydraulic Components - Relief Devices

  Relief Devices FluidFlow allows you to model two types of relief devices, relief valves, and bursting discs. Users have the option of defining the size of the valve or disc or alternatively, allowing the software to automatically size the components ...

• Hydraulic Components - General Resistances

  General Resistances There are many types of pipe fittings that offer resistance to flow that don’t fit logically into the existing component groups. These types are available from the General Resistances of the Component palette. The resistance of ...