How do I model a closed-loop system

How do I model a closed-loop system


When modeling closed loop systems, we need to include a reservoir node (simply to assign a fluid, pressure and temperature) to the system. The reservoir node is modeled "in-line" and upstream of the pump node. The image below gives an example of this modeling approach. 

Note, closed loop systems can also be modeled using known pressure boundary nodes (see lower model in the image below). This simplified case in the screenshot shows an identical system which has been modeled using both approaches. The results developed in both cases are the same. You can therefore use either approach when modeling your closed loop systems.



    • Related Articles

    • Cooling System Modeling

      Let's say we have heat energy of 40 kW at a piece of equipment (heat exchanger etc) and we know the pressure loss for this item is approx. 15 l/min @ 0.6 bar. We can define this condition using a Kv node as shown below. In terms of heat transfer, we ...

    • How do I model a submersible pump?

      When modelling a submersible pump which of course has no suction piping, it is necessary to insert a short section of pipework between the model inlet boundary and the pump suction connection. This is necessary to complete the model connectivity. The ...

    • Are you able to model two different fluids from a heat exchanger?

      Scenario: Say we want to analyze the cooling in a system where we have two separate flows, one of chilled water, and one of warm air to be cooled using the heat exchanger. Answer: In relation to the heat exchangers, we need to create one model of the ...

    • Can I model a Vapor Quality value of 0 or 1?

      When we set the Fluid Type to Two Phase, we are required to enter a value for Quality (Vapor Quality). Vapor Quality has a range of 0 to 1 where 0 represents 0 % vapor and 1 represents 100 % vapor. So, if we entered a quality of 0.2604, this would ...

    • Modelling Expansion Tanks

      FluidFlow doesn't include or allow an expansion tank to be modeled in-line in a system as this would tend to be a dynamic type of scenario (fluctuating pressure/expansion) whereas in FluidFlow we tend to be solving static system conditions. Queries ...